|
|
|
Dec 15, 2009 12:59:32 GMT
|
|
Ok, the gearbox on my '94 205TD has just gone bang. I can get a replacement from a 306TD, which I have been told will fit, but the scrappy reckons not.
Anyone shed any light?
|
| |
|
|
|
|
|
Dec 15, 2009 14:24:45 GMT
|
As far as I know the XUD9 engine in all 306 dturbos and the like use the BE3.5 box. Prior to '95 the XUD7 in the 205 Diesels used the BE3, after that they changed to the BE3.5. You should find a BE3 in a Diesel Citroen BX, but I don't think the BE3.5 will fit on the pre '95 XUD7. I'm not sure if the MA box was used on 205 Diesels, but if they did then they are totally different to the BE boxes, here is a picture of an MA-5  And this is a BE  |
| |
|
|
|
|
|
Dec 15, 2009 16:17:21 GMT
|
|
Probably the 'it won't fit' comes from the fact that the 306's use a 'pull type' cover rather than a 'conventional' push.
As far as I know the casings (BE3 ?) are the same and you can simply (with a set of punches, a lump hammer and a gallon of WD) change the clutch actuation mechanism over..
Hope that helps
|
| |
'A' series trigger wheels and sensor brackets, 205 GTi radiator brackets, general fabrication and machining - www.gsmotorsport.net |
|
|
|
|
Dec 15, 2009 16:25:48 GMT
|
|
I stand corrected Phil.
|
| |
|
|
|
|
|
Dec 15, 2009 16:53:03 GMT
|
|
Dave, talk to Daddy Damaged....he's got a '92 405TD engine/box down at his.....
|
| |
|
|
