Hi there folks any ideas where I can get specific measured sleeve nuts from, I have tried everywhere!
They're for a Datsun alloys, measurements as follows:
m12 x 1.25 thread
17mm diamter
15mm long shank
21mm hex head
I live in Brum so ideally anywhere close-ish but I do not mind ordering them - if anybody could help I would really appreciate it.
Thanking everyone in advance.
They're for a Datsun alloys, measurements as follows:
m12 x 1.25 thread
17mm diamter
15mm long shank
21mm hex head
I live in Brum so ideally anywhere close-ish but I do not mind ordering them - if anybody could help I would really appreciate it.
Thanking everyone in advance.