Just though I'd bring everyone upto date over here
Day 8 of ownership - Not much done today, I got the old flitch panel removed and prepared for the new panel, just the bottom of the windscreen to sort now and then get the welder out
There wont be any updates for a few days as the weather is not looking good until Saturday, so the min has been tucked up is a warm blanket
Day 13
After much deliberation upon discovering the A Post was shot I've decided to replace the whole A post and O/S inner wing.
So it was out with the, drill, dremel and grinder again
Day 14 of ownership
Finished work @ 3, collected inner wing, got to work on the min
Only screwed on at present, hoping to get it all welded up tomorrow night
Day 15
The panels and big hole required to replace the A Post and inner wing
Day16 rain rain rain
So I put up the gazeebo to work under
The front is all screw on now, just got the final panel alignment to do before I fire up the welder
Anyhoo on to the pics
Its a mini again
Day 26
After not having any time this week thing have slowed down but I got the inner wing, bulkhead and scuttle done today
Day 27 - Sunday 12th August
N/S almost ready for A panel
Hole in O/S floor to deal with
Removed rear subframe and found more holes
Sheared off one N/S bolt, i'll weld a nut on to remove it but at least the heal board looks ok
The old subframe Mmmmm, remember this still has over 8 months MOT
Day 8 of ownership - Not much done today, I got the old flitch panel removed and prepared for the new panel, just the bottom of the windscreen to sort now and then get the welder out
There wont be any updates for a few days as the weather is not looking good until Saturday, so the min has been tucked up is a warm blanket
Day 13
After much deliberation upon discovering the A Post was shot I've decided to replace the whole A post and O/S inner wing.
So it was out with the, drill, dremel and grinder again
Day 14 of ownership
Finished work @ 3, collected inner wing, got to work on the min
Only screwed on at present, hoping to get it all welded up tomorrow night
Day 15
The panels and big hole required to replace the A Post and inner wing
Day16 rain rain rain
So I put up the gazeebo to work under
The front is all screw on now, just got the final panel alignment to do before I fire up the welder
Anyhoo on to the pics
Its a mini again
Day 26
After not having any time this week thing have slowed down but I got the inner wing, bulkhead and scuttle done today
Day 27 - Sunday 12th August
N/S almost ready for A panel
Hole in O/S floor to deal with
Removed rear subframe and found more holes
Sheared off one N/S bolt, i'll weld a nut on to remove it but at least the heal board looks ok
The old subframe Mmmmm, remember this still has over 8 months MOT