Hello,
As some of you already know, I make bits for the Mini Cooper S Supercharger as found on Ebay
Basically all the difficult to make bits you don't get with the chargers ;D
I am just letting you know, that I will have the new
Supercharger inlets with me next week.
These are Fabricated from Aluminium to fit the Awkward
Inlet Flange on the Mini Cooper Superchargers.
They will use the standard Cooper S Gasket, which I
will again supply the part number for.
This keeps the sealing strategy developed by BMW
intact, and gives you one less thing to think about !!
The 1st batch will be done to mate with a 2.5" inlet
hose, which is the size inlet recommended by Eaton,
to give the least restriction.
The standard Cooper S Throttle body is 62mm so we are
no worse than that.
2.5" ID Hose is easily available from Samco in a
variety of shapes/bends etc.
It may be possible to do 3" or 2" versions as well.
If there is enough interest, I could provide inlets
with a Flat plate for those that need to make a
manifold to suit SU/weber Carbs, or wanting to mount a
Throttle body direct to the charger.
Sorry for the blatant Spam but I figured you would be
interested in this as all the hard work has been done
for you !!
Now with my outlet plates as well there is no excuse to not supercharge that Retro Ride ;D ;D
Cheers
Dom
As some of you already know, I make bits for the Mini Cooper S Supercharger as found on Ebay
Basically all the difficult to make bits you don't get with the chargers ;D
I am just letting you know, that I will have the new
Supercharger inlets with me next week.
These are Fabricated from Aluminium to fit the Awkward
Inlet Flange on the Mini Cooper Superchargers.
They will use the standard Cooper S Gasket, which I
will again supply the part number for.
This keeps the sealing strategy developed by BMW
intact, and gives you one less thing to think about !!
The 1st batch will be done to mate with a 2.5" inlet
hose, which is the size inlet recommended by Eaton,
to give the least restriction.
The standard Cooper S Throttle body is 62mm so we are
no worse than that.
2.5" ID Hose is easily available from Samco in a
variety of shapes/bends etc.
It may be possible to do 3" or 2" versions as well.
If there is enough interest, I could provide inlets
with a Flat plate for those that need to make a
manifold to suit SU/weber Carbs, or wanting to mount a
Throttle body direct to the charger.
Sorry for the blatant Spam but I figured you would be
interested in this as all the hard work has been done
for you !!
Now with my outlet plates as well there is no excuse to not supercharge that Retro Ride ;D ;D
Cheers
Dom