Full tube framed, roll cage chassis. Built on a 1967 vw beetle pan - i do have the v5
The beam has adjusters fitted and is narrowed 4".
The rear end is IRS.
Californian front clip (completely rust free!)
vw beetle 1966 shell has got new heater chanels, hookeys door bottom himges, hookeys rear bumper mounts, and very little rot!
IRS 1303 gearbox and drive shafts
it is a project but a very good one at that... a great basis to start from.....
its the rolling tube framed chassis with roll cage... includes the 66 shell with front clip and hookies bits (no doors/ panels)
4" narrowed lowered beam,
irs gearbox irs back end,
here are some more pics.... the shell.....
and note I'm being verty honest as theres nothing worse than coming for a car that isnt what you expected!
good bits:
new heater channels in
hookies door bottoms are in
rust free cal front clip already cut/matched to size ready to be welded on
uncut dash
bad bits:
it needs the rear 'strips' for both sides finishing rear 1/4
where the guttering meets the decklid needs attention on both sides
the chassis it is on in the pic is NOT the one that comes with it obviously
as i said before its a great basis for a cracking car.... we just don't have the time to give this the attention it deserves due to the little rug rats!
£500 ono
any queries please email
intheweeds at btinternet dot com
;D
The beam has adjusters fitted and is narrowed 4".
The rear end is IRS.
Californian front clip (completely rust free!)
vw beetle 1966 shell has got new heater chanels, hookeys door bottom himges, hookeys rear bumper mounts, and very little rot!
IRS 1303 gearbox and drive shafts
it is a project but a very good one at that... a great basis to start from.....
its the rolling tube framed chassis with roll cage... includes the 66 shell with front clip and hookies bits (no doors/ panels)
4" narrowed lowered beam,
irs gearbox irs back end,
here are some more pics.... the shell.....
and note I'm being verty honest as theres nothing worse than coming for a car that isnt what you expected!
good bits:
new heater channels in
hookies door bottoms are in
rust free cal front clip already cut/matched to size ready to be welded on
uncut dash
bad bits:
it needs the rear 'strips' for both sides finishing rear 1/4
where the guttering meets the decklid needs attention on both sides
the chassis it is on in the pic is NOT the one that comes with it obviously
as i said before its a great basis for a cracking car.... we just don't have the time to give this the attention it deserves due to the little rug rats!
£500 ono
any queries please email
intheweeds at btinternet dot com
;D
