![](https://img.retro-rides.org/i/v/vulgalour/770509e83511.jpg)
Full set of four Lotus Elite alloys with sixteen of the correct tapered sleeve lightweight Lotus wheel nuts. These are remarkably a straight fit on an Austin Princess, even the wheel nuts, so would look equally at home on an Ambassador.
PCD - 4 x 114.3
Width - 7J (I think, don't quote me on this)
Diameter - 14"
Not sure on the offset, they're originally a rear wheel drive application so they stick out a bit on the front wheel drive Princess as shown above.
The wheel nuts are original Lotus and specifically for these wheels having a very slightly tapered sleeve and being very lightweight. Four weigh about as much as one standard steel wheel nut.
I don't have any centre caps to go with them, sorry about that.
![](https://img.retro-rides.org/i/v/vulgalour/a7e396f1ad1b.jpg)
![](https://img.retro-rides.org/i/v/vulgalour/4fda752149ff.jpg)
![](https://img.retro-rides.org/i/v/vulgalour/9753bccab410.jpg)
![](https://img.retro-rides.org/i/v/vulgalour/eef94e5b5108.jpg)
![](https://img.retro-rides.org/i/v/vulgalour/e22f6ba1ba75.jpg)
![](https://img.retro-rides.org/i/v/vulgalour/adb389dd89a1.jpg)
To my knowledge these have never been refinished, though they are in need of it now as the original paint and lacquer is on the way out. No curbing, dents, wobbles, or other damage that I can see and when I ran them on the Princess they needed minimal balancing.
£350 for the wheels and wheel nuts, collection very much preferred.