Hello,
For my brake upgrade i need to fix 5 wheel studs in a metal flange in a way that prevents them from turning.
I've seen some of those press-in wheel studs, those with a knurled piece that presses into the hub from behind. That would be perfect for my flanges.
My question is how do i determine the exact drill size for the hole? None of the suppliers that i've asked could tell me the needed size hole.🙁
If the knurled part is 13,0mm should i drill it to 12,5 or 12,8 or what would you recommend as a rule of thumb?🤔
In the past i fooked up a brakedisc by pulling a stud in a whole that was not big enough. I would like to prevent that this time😅
For my brake upgrade i need to fix 5 wheel studs in a metal flange in a way that prevents them from turning.
I've seen some of those press-in wheel studs, those with a knurled piece that presses into the hub from behind. That would be perfect for my flanges.
My question is how do i determine the exact drill size for the hole? None of the suppliers that i've asked could tell me the needed size hole.🙁
If the knurled part is 13,0mm should i drill it to 12,5 or 12,8 or what would you recommend as a rule of thumb?🤔
In the past i fooked up a brakedisc by pulling a stud in a whole that was not big enough. I would like to prevent that this time😅
