As cb11acd (and a number of other forum members) will no doubt back up R-Tech make great products and because they have come on board to help support the shows so we can turn various bits of the events up to eleven, it means we've also got some cool discount tie ins. Today (until Friday) you can get 10% off one of their plasma cutters.
What Is Plasma Cutting? (I hear some of you say)
Plasma cutting is a quick and simple way to cut any metal that conducts electricity. Operating a hand-held plasma cutter is actually very simple.
How Does A Plasma Cutter Work?
Plasma cutters use DC voltage to heat compressed air to a very high temperature, where it ionises the atoms and creates a "plasma arc". This flows through the narrow hole of the cutting tip (normally 0.9mm - 1.5mm) at a temperature of about 25,000 - 30,000 degrees Fahrenheit.
The small jet of plasma pushes through and melts the metal and pushes the molten metal away. It is highly focused when compared to oxy-fuel cutting and comparative results.
So, basically, science.
You can read more here : www.r-techwelding.co.uk/plasma-cutting-how-to-use-a-plasma-cutter-guide/
and you can use code RRP30C
for a 10% discount on : www.r-techwelding.co.uk/plasma-cutter-r-tech-p30c/
Which looks like:
and you can get some lovely video here:
So there you have it, if you cut metal and want to use the super future power of science to do it cleanly, easily and smoothly, go grab one of these.
What Is Plasma Cutting? (I hear some of you say)
Plasma cutting is a quick and simple way to cut any metal that conducts electricity. Operating a hand-held plasma cutter is actually very simple.
How Does A Plasma Cutter Work?
Plasma cutters use DC voltage to heat compressed air to a very high temperature, where it ionises the atoms and creates a "plasma arc". This flows through the narrow hole of the cutting tip (normally 0.9mm - 1.5mm) at a temperature of about 25,000 - 30,000 degrees Fahrenheit.
The small jet of plasma pushes through and melts the metal and pushes the molten metal away. It is highly focused when compared to oxy-fuel cutting and comparative results.
So, basically, science.
You can read more here : www.r-techwelding.co.uk/plasma-cutting-how-to-use-a-plasma-cutter-guide/
and you can use code RRP30C
for a 10% discount on : www.r-techwelding.co.uk/plasma-cutter-r-tech-p30c/
Which looks like:
and you can get some lovely video here:
So there you have it, if you cut metal and want to use the super future power of science to do it cleanly, easily and smoothly, go grab one of these.
