as above, got a new kent a2 cam, it is around 2/3 degrees out, and I stupidly thought I know what instead of buying a Vernier I will do it the old way and buy a dowel and slot the holes. tried punching it out with a drift but my drift broke . now I regret this option lol, but the dowel is a curse word to budge.
can I use a bit of heat and mole grips again ? any other tips as if you know a xflow cam, tapping it from behind is a pain because it is very close to the cam bearing journals (already scrubbed a bit but just on the edge and have gently filed it back..)
any help or should I just farm it out to a machine shop/engine builder?
thank in advance. always go with the lazy option in the future lol
can I use a bit of heat and mole grips again ? any other tips as if you know a xflow cam, tapping it from behind is a pain because it is very close to the cam bearing journals (already scrubbed a bit but just on the edge and have gently filed it back..)
any help or should I just farm it out to a machine shop/engine builder?
thank in advance. always go with the lazy option in the future lol
