omex 100 3D mappable ignition

RetroWarwicK Posted a lot Searching...... Posts: 3,906	omex 100 3D mappable ignition RetroWarwicK @maph2
	Jun 12, 2013 20:27:06 GMT Select Post Deselect Post Link to Post Back to Top
	I've got an ignition only omex 100 Ecu and loom, data cable, throttle pot, and some crank sensors. Got it a few years ago when I was installing the redtop in the mini. In the end decided to full throttlebody fuel injection so this kit wasn't used. It is set up and used on a Peugeot MI16 engine, but is fully mappable. I powered it up when I bought it years ago to check it was ok but otherwise it's been in the box in the garage for a few years. £210 including post. Pics up tomorrow when u get to the office. Thanks Matt
	Matt 1979 Mini Marcos 1974 BSA Ariel3 1990 Honda Vision NE50 Youtube garbage: www.youtube.com/channel/UCcOzz5STAZUyAdZfuV193wQ

	Reply Quote

RetroWarwicK Posted a lot Searching...... Posts: 3,906	omex 100 3D mappable ignition RetroWarwicK @maph2
	Jun 13, 2013 7:50:04 GMT Select Post Deselect Post Link to Post Back to Top
	I've noticed that the crank sensor cable has been cut (by the PO). its on the upper section before the connector so can be soldered/reconnected together. everything is labelled. you would just need a need coilpack and probabaly a usb adaptor for the data cable. make me an offer - these are/were abut £250 for the ECU then about £100 for the loom plus throttle pot and crank sensor. Full support by omex as they emailed me a base map for the redtop. cheers Mat
	Last Edit: Jun 13, 2013 7:52:32 GMT by RetroWarwicK Matt 1979 Mini Marcos 1974 BSA Ariel3 1990 Honda Vision NE50 Youtube garbage: www.youtube.com/channel/UCcOzz5STAZUyAdZfuV193wQ

	Reply Quote