|
|
|
|
|
|
Try dave at llama4x4 he keeps a massive stock.
Be prepared to have your ears talked off though.
|
| |
Ginetta G15 BMW K1100 conversion Sold
Mk1 Mx5 on ITB'S Sold
TVR Chimaera 400 supercharged
MR2 Red Roadster 2ZZ
Bee*R 324 Skyline
95 Cherokee Jeep
|
|
|
|
|
|
|
 If I'd seen this link earlier I could have offered a possible solution. All I'd need is the diameter of your rear axle (at the point where the u-bolts mount) because I have a bag full of U-bolts I had made for my Delica (specified for use on a 2.5 ton vehicle from an automotive engineering company) I'd also have been happy to make you a set of lowering blocks too complete with locating pins/holes - I did the same for Speedy and his Volvo. Offer of fitting too. If you get stuck at all, just give me a shout.  |
| |
|
|
Dez
Club Retro Rides Member
And I won't sit down. And I won't shut up. And most of all I will not grow up.
Posts: 11,712
Club RR Member Number: 34
|
Suppliers of custom U boltsDez
@dez
Club Retro Rides Member 34
|
|
|
|
you never told me that bruce- can you get me specs on one, i need a new set for the pickup.
|
| |
|
|
PHUQ
Part of things
Posts: 859
|
|
|
|
You are a legend Bruce. If these bits don't do the trick (or if they simply aren't low enough ), I shall give you a call. Thankyou Sir  |
| |
|
|
PHUQ
Part of things
Posts: 859
|
|
May 12, 2012 17:59:06 GMT
|
Wibble. MM axles it would slightly smaller in diameter than Marina ones... botherations! The blocks in the kit look better than mine however. Bruce, I shall do some measureificating and give you a call |
| |
|
|
topcat
Part of things
Posts: 289
|
|
May 13, 2012 12:30:04 GMT
|
|
I actually work for ESM, I was going to say I can always have a measure up for you but I won't be into work until Tuesday, one of the other guys can always help if you call 01580 200203.
|
| |
|
|
PHUQ
Part of things
Posts: 859
|
|
May 15, 2012 21:37:44 GMT
|
I actually work for ESM, I was going to say I can always have a measure up for you but I won't be into work until Tuesday, one of the other guys can always help if you call 01580 200203. Sorry mate, just spotted this. Ordered a kit from you, cracking service but sadly the MM axle is slightly smaller in diameter so they don't fit. The blocks themselves look like they will though. |
| |
|
|
[*]
[*]
