Clicking on eBay [or other affiliations] may result in referral commission being paid if a purchase is made.

Vectra help needed.....

CR500Dom Posted a lot Posts: 4,935	Vectra help needed.....CR500Dom @cr500dom
	Mar 22, 2012 19:52:21 GMT Select Post Deselect Post Link to Post Back to Top
	Bear with me I've just brought a concentric clutch release bearing set up from a vectra. What I need to know is some measurements ? Bellhousing face on gearbox to clutch release bearing And bellhousing face on engine to installed clutch fingers ( effectively where the CRBrg depresses the clutch) This will enable me to make a spacer / adaptor to fit it to my Ford type 9 box Many thanks and happy to share the knowledge / measurements for anyone else trying to do the same ? Cheers Dom
	Supercharged Kadett Build on Retro-rides: retrorides.proboards.com/index.cgi?board=readersrides&action=display&thread=36727&page=1 Golf2 Syncro Build on Retro-rides: urlfairy.com/4z Sept 12, 2008 10:10:09 GMT @Hotwire said: I have no modesty.. I am literally amazing.

	Reply Quote

mantaphil Part of things Posts: 154	Vectra help needed.....mantaphil @mantaphil
	Mar 25, 2012 22:23:03 GMT Select Post Deselect Post Link to Post Back to Top
	think i can help if you still need it. what vectra did the concentric slave cylinder come from? just to check so i get it right; 1) measure the distence from the edge of the gear box to the top of the CSC 2) measure width of the clutch and flywheel from the engine block to the end of the clutch carrier. phil


	Reply Quote