Hey all, another one for me on my never ending session of niggles on the corsair and me learning new things too!
right basically i have a new indicator unit to replace the severely wrecked unit in it ATM, basiclly the wiring is a bit too short by about 30cm.. this is because my model is a 64 version and i got a unit from a v4 one, and the loom on the indicator is shorter and original 1500 ones are much harder to come by. And yes it still will work just looking for the 'correct' way to extend the loom by 30cm
tried bullets but bought some which are too small!! got the correct wire here, what other joining technique(apart from soldering) could i use and what will work?
other than that sorted all the other electrical buggeries, not bad for me ;D
cheers guys- i know this may sound stupid this whole question but I'm young and eager to learn all these basics hence - promise no more after this I'm done haha
Gav
right basically i have a new indicator unit to replace the severely wrecked unit in it ATM, basiclly the wiring is a bit too short by about 30cm.. this is because my model is a 64 version and i got a unit from a v4 one, and the loom on the indicator is shorter and original 1500 ones are much harder to come by. And yes it still will work just looking for the 'correct' way to extend the loom by 30cm
tried bullets but bought some which are too small!! got the correct wire here, what other joining technique(apart from soldering) could i use and what will work?
other than that sorted all the other electrical buggeries, not bad for me ;D
cheers guys- i know this may sound stupid this whole question but I'm young and eager to learn all these basics hence - promise no more after this I'm done haha
Gav