Hey all.
Currently swapping engines in my ph1 DT pug 306
I knew the wiring looms were different, so swapping the complete looms over.
All rigs up nicely, apart from:
The new engine is a ph2 DHY engine with a XUD110 fuel pump...
the loom is off a Ph1 D8A engine with a XUD103 fuel pump.
The problem I'm facing, is on the XUD110 pump, there is a blue plug (3 pin) which look like it goes round the back of the pump.
The XUD103 pump however, doesn't have this blue plug, so I am a plug short on the wiring loom.
Can anyone tell me what the plug blue powers, and can the engine run sweetly with nothing pluged in? or am I looking at a pump swap?
Thanks all.
Currently swapping engines in my ph1 DT pug 306
I knew the wiring looms were different, so swapping the complete looms over.
All rigs up nicely, apart from:
The new engine is a ph2 DHY engine with a XUD110 fuel pump...
the loom is off a Ph1 D8A engine with a XUD103 fuel pump.
The problem I'm facing, is on the XUD110 pump, there is a blue plug (3 pin) which look like it goes round the back of the pump.
The XUD103 pump however, doesn't have this blue plug, so I am a plug short on the wiring loom.
Can anyone tell me what the plug blue powers, and can the engine run sweetly with nothing pluged in? or am I looking at a pump swap?
Thanks all.
