mada01
Part of things
Posts: 54
|
|
May 21, 2024 13:49:38 GMT
|
Finally finished the rear seat delete today Very happy with the finish. Plan to make a bar to go where the rear seat brackets are normally and attach a net to it which will separate where the gti fabric tartan is and the black carpet starts
|
|
|
|
|
mada01
Part of things
Posts: 54
|
|
May 16, 2024 16:55:36 GMT
|
And here is a little tease to show you the fabric I've gone for the rear delete and the door cards. Plans may change with the front seats now as the gti tartan fabric may clash with the tweed but I'll see once it's all in and finished. Also changed the steering wheel hub and finally got the horn working
|
|
|
|
|
mada01
Part of things
Posts: 54
|
|
May 14, 2024 16:48:29 GMT
|
Managed to finish the carpet in the rear along with the side panels. Have refitted the rear washer tank for a future project next year Also removed the clear rear wiper plug as it was leaking and fitted just a plain grommet. Started on the fales floor then ran out of time
|
|
|
|
mada01
Part of things
Posts: 54
|
|
May 13, 2024 15:59:52 GMT
|
Cheers Jim much appreciated So started the retrim on the headliner. All orginal holes covered up with aluminium tape to make them less obvious Then used 4 way stretch carpet on the roof and did the b and c pillars as separate pieces. Decided to keep the a pillars orginal in the black vinyl as it was in good condition And managed to finish the passenger side rear panel And with the panel rested in place Plan is to recover the side panels in the black carpet too and have the clips glued to the under side before retrimming to give a clean look. Should get it finished tomorrow and make a start on the false floor
|
|
|
|
mada01
Part of things
Posts: 54
|
|
May 12, 2024 22:20:38 GMT
|
Another smaller update for now, Added sound deadening to the roof and boot floor And as the saying goes, 'sounds just like a golf' Fitted the boot seal and the leaks where it was leaking has sealed lovely. Only issue now is a new leak in the bottom middle of the window, will address this tomorrow. Once the rear end is finally water tight, plan to carpet out the rear and also the roof lining at same time. Aim to have most of the touching up bits of the car done for a local car show in roughly 4 weeks time. Then enjoy the car for summer and begin to source parts for a engine conversion!
|
|
|
|
mada01
Part of things
Posts: 54
|
|
|
So after a bit of fettering we managed to get the seat frames and seats fitted. The 53fab subframes are made for a mk1 golf so needed soon slight adjustment with Mr angle grinder to fit and cut the drivers side height down due to sitting too high. Still thinking of doing a possible foamectomy to make the seat sit lower. I did the same as I did with the passenger seat do its on the leon fr seat bases for added side bolster support on the bases. Still got the plastics to refit
|
|
|
|
mada01
Part of things
Posts: 54
|
|
|
Cheers! But more progress on this, Found the leak! It was coming in through the rear window zeal. Luckily I had one spare, so whilst the missus was at work I gave it a clean It definitely needed it Also got the tires of the banded steels and my friend started work on rubbing through the billion layers of paint Turns out they are 7.5j wide after measuring them. A parcel turned up which is the seat frames to fit the new seats, will tackle this job tomorrow along with a few others
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Mar 28, 2024 19:16:56 GMT
|
Managed to get the other parcel shelf support off and tidied up. Got a few bits to clean up and tidy up next Also did a bit of modifying on the new seats. I had some seat leon fr seats lying around from a previous build so I used the base frames and back from them and swapped the foam across from the new seats onto this. It has made the bases more supportive in the bolster and the seat a lot lighter! Seat on the left is the modified one. Will do the drivers side one next week. Have also ordered some seat bases adapters that should make fitting a lot easier!
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Mar 27, 2024 20:18:39 GMT
|
The scirocco took a bit of a rest whilst going through the bad weather Leak in the boot got worse so decided to strip the rear of the interior to locate it and kinda got carried away! Have now decided to keep the rear seats out and do a seat delete in the back and remove the parcel shelf supports to make a cleaner rear end. Removed the support from one side And you can see how cleaner it becomes This is a few pictures that I am aiming for Also picked up some new seats which I got off Facebook market place for a steal And after a clean Got the seats for £20 which were removed from a new beetle pickup conversion. They have been retrimmed in the past with no expense spared on brown leather and tweed. I love the look of them and feel they will go well with the black and red of the car. I believe the seats are from a mk1 touran. Going to order some mk1 golf seat adapters to make fitting them slightly easier. Also I've fixed the no speedo fault I was having. Appears the gear input in the gearbox end decided to live inside the gearbox. A new one fitted with no issues. I've signed up to a few shows in summer so have a deadline with getting the interior sorted and the wheels sorted ready for them. Will update with more pictures when I can!
|
|
|
|
|
mada01
Part of things
Posts: 54
|
|
|
I'm thinking either Silver or black for the wheels when I finally get round to them!
Hope everyone had a lovely christmas and a good new year.
bought some new parts for the Scirocco so ill update the thread once they have arrived!
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Dec 14, 2023 17:02:32 GMT
|
Sorry for the lack of updates, weather has not been on my side! So the parcel from poland arrived and was fitted, Has changed the rear end massively Fitted new spoiler seals whilst the spoiler was off to fit. Finally got chance to put the coilovers on. Rears were a doddle and got both sides done and on in 30 minutes huge difference in size from old and new ones! Fronts were a different story and took a lot longer to do. Fitted new front top mounts at the same time as the old ones were completely shot. Once fitted had to readjust them and add a small 5mm spacer on the front as the tyres were rubbing against the springs. These wheels won't be staying, but still needed it to be drivable! Retro ride sticker also fitted Back end needs to come up slightly and will add spacers on the rear until I get the new wheels refurbed and on. Got the interior all cleaned up Need to change the seats as they aren't the original ones from a GT2. I believe they are from a earlier model and that's why they are grey. Think of trying some different front seats but I will see what comes up. Now a few more issues have popped up - Speedo stopped working, I have taken the speedo out and checked the cogs behind and they are still working ok, so it must be gearbox end, will get a new speedo cable for this - broke one of the window wipers, just need to order another - Still have a leak in the boot. I believe there is rust behind the rear window seal, so I will need to investigate this further - Slight fuel leak still there event after replacing the pipe, again I believe this is the filler pipe, so will need to get a new one or get this one repaired Really enjoying the car still, but will be getting used less as the weather gets worse!
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Nov 29, 2023 16:31:09 GMT
|
Thanks for the hints about brakes. When test fitting the new wheels today i found the fronts have already been changed from solid discs to vented. so next step will be 260mm i reckon as it'll have to fit under the 14inch wheels. Still in the middle of sanding and stripping them so please ignore the state of them and tyres need inflating. Just need to get the wheels finished and it lowered. Should hopefully try and get the coilovers fitted this weekend if all goes well. The tyres are different profiles, the rear are 55 and the fronts are 45. Most likely I will get tyres changed and go for same profile all the way round
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Nov 26, 2023 22:19:33 GMT
|
love seeing everyones old sciroccos! Craig1010cc - what audi brakes did you fit? Not had chance to do much on the car recently due to work and family. Did manage to pick up a set of wheels 14inch banded steels, originally golf steels. about 9J in width and in need of a refurbishment! just placed against the current wheels Gave them a quick clean and some of the paint cleared with just a jet wash Paint stripper applied and this is where we are at tonight Will see how they look in morning but will either give them a sand or more paint stripper then a sand. Thining of going for a statin black for them with a satin lacquer Again thanks for all the nice comments so far!
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Nov 26, 2023 20:11:03 GMT
|
Looks like a good base to work on!
The centre display Looks like the middle bulb has gone and that's why it's slightly darker.
Has it got the trip button on the stalks for the centre display? If not you can change the stalks and it should give your mpg, miles to empty etc on it
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Nov 26, 2023 10:47:24 GMT
|
you had me at free pie....
|
|
|
|
mada01
Part of things
Posts: 54
|
|
|
So managed to do a bit more to the car this week. Took the rear lights out to reseal them and found a few spider nests which were quickly removed! Also managed to remove the blank for the 2nd rear fog light, just need to pick up a bulb for it. Removed the standard steering wheel and got the new one fitted. Feels a lot better now. Also fitted a universal back box to the rear. Previous owner had done a back box delete and it was far too loud. Sounds a lot better and I can hear myself think now in the car too Will get better pictures once Ive got the car cleaned up
|
|
|
|
mada01
Part of things
Posts: 54
|
|
|
Managed to fit the centre console back in today, will need to come out again to wire up the gauges.
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Nov 16, 2023 18:31:34 GMT
|
Not sure if it’s been mentioned , but re seal the rear lights , mine was leaking through both . 👍 Do the rear lights have seals? Or is just a case of cleaning and using sealant? Cheers!
|
|
|
|
mada01
Part of things
Posts: 54
|
|
Nov 16, 2023 18:04:31 GMT
|
For all the Louvre lovers out there, it has been completed and has been posted out today to myself! hopefully arrive towards the end of next week. Managed to get a few little jobs done on the car today. I still have a leak coming in the boot, the boot lock seal looks pretty suspect, most likely the original still! Replaced with one from Dreadnought customs The actual seal was also split. The rear badges are held on by little grommet things, which looking at the state of the ones fitted needed changing too. One of the previous owners also painted over them. Ive had to order another 2 as I only ordered 6 In my dreadnought custom order, the gauge holder also arrived I need to remove the ashtray to get to fit, and fitted Will hopefully refit it to the car tomorrow. The gauges will still need wiring up but will get to that once ive ordered the new sensor for the oil pressure. Also tried to fit the steering wheel, but the boss is the wrong size. Need to purchase one with a smaller spindle, then it should fit with no issue. A new exhaust has also arrived, just a universal back box but it should help quiet it down a little!
|
|
|
|
|