stand alone wiring help???

carmad Posted a lot Posts: 2,000	stand alone wiring help???carmad @carmad
	May 9, 2010 18:12:40 GMT Select Post Deselect Post Link to Post Back to Top
	i was gonna post this in the amnistey thread but i am completely lost i have a coil pack vauxhall engine x20xev i have the ecu transponder and chipped key but there is no wiring diagrams that i can find for it anywere and i have tryed to get it going on the floor but its not happening i am only getting a spark when i stop cranking (so i am putting it down to chipped key related ) as the fuel pump ect is running i have looked at a stand alone type but i am really confused as to which way to go as there is so many i tryed reading about mega squirt but there so many different types old boards /new boards /versions /wasted spark ectect its just so confusing to any one starting out on a project so can some one suggest a simple solution that wont cost a fortune and is idiot proof to wire up ??


	Reply Quote

Good Scrap Part of things Posts: 290	stand alone wiring help???Good Scrap @goodscrap
	May 9, 2010 22:24:35 GMT Select Post Deselect Post Link to Post Back to Top
	have you re-wired the ignition switch? if so could be the ECU/ignition feed is off the auxillary connection rather than the ignition connection. most ignition switches kill the power to the aux terminal during cranking. a quick work round might be a starter button to fire the starter leaving the ignition swith in the position where you're currently getting a spark.


	Reply Quote