bonding rubber/metal gearbox mount

Originals are expensive (£30-£40!) But sometimes come up for under £20 (still expensive!).
I could modify the bracket but id rather keep it stock.

Ill find a pic of one in case anyone knows of something similar.

Phone loctite. We used to make mountings and use one of their products. Can't remember the number off hand, but it did involve using a purple coloured polyolefin primer.

Its not a question of quality.
There all the same.
But there is one supplier who charges alot who I can get one from tomorrow, or I can refuse to pay his prices and wait for the same part to come up on ebay.

I might have to give in but I don't want to pay £40 plus post now when I can get one later if I wait for less than half that.

I need quite a few parts and its the same story with all of them.

Pay the specialists prices or wait for them to come up at a reasonable price.

Its the difference between it costing me £500 to get my parts or £1000+.

Tiger seal or sikkaflex then drill a 3.5mm hole through the metal bonded plates and send a fairly long self tapper through and into the rubber to take the strain of the glue . Cut the heads off the screws when tight and job done .
Used this on a few hard to find mounts and never had one come apart again .