where can I buy just a clutch driven plate?

I've looked all ready, as yet not found one....

I do love a top secret post !
as above ebay is usually the best place to get parts of things that usually come in kits, possably here if like we new knew what car you want it for

No secret, I've a driven plate from ebay, correct spline count too small diameter.....its for a XUD19td using a HDI flywheel, Ford Galaxy 2L 228mm jobbie.... thanks

I've used a LDV box & XUD combo before in an old Volvo.Both this time & the last time I found that there is no spigot bush in the Pug engine when I've removed the box.I did not use a spigot bush in the Volvo with no issues, so i don't think i'll bother this time either.
I spoke to my local garage who tell me a lot of cars don't use spigot bushes/ bearings these days, though I quess it's more to do with the design of the box...

Yes i agree if the bell housing is centered,I've built some turbo Rover V8's & the only way to get the old LT77 box's to live would be to use ball races & dial gauge in the bell housings using off set dowels.
Factory bell housing can be off center a fair amount , & if taper bearings are used they are very unforgiving of misalignment & slack.
Looks like r380 box's are fitted with taper bearings, I wonder if LDV were not fitting spigot bearings due to misalignment & subsequent gearbox wear problems? .It is rather strange that both engines I've split don't have them fitted?