sold sold sold sold
got a lathe to sell for the father in law
it’s a myford tri leva with screw cutting attachment
runs on 240volt!!!
lots of tools 3&4 jaw chucks
from what i measured us an 8” chuck capacity
approx 1.4mts high at the chuck end on its 1.4mt suds tray and stand
approx 60cm deep
i have just done a small batch run of parts using the 3&4 jaw chucks and it worked perfectly , the father in law is currently cleaning this up.
i have demolished the shed it’s in and would be good to sell this before i have to move it into storage.
lots of bits and pieces with it and he has some old engineering tools etc from when he was building a live steam engine, ill health means he has had to give that dream up some time ago
collection only near junction 4 M25
£900 or near offer
got a lathe to sell for the father in law
it’s a myford tri leva with screw cutting attachment
runs on 240volt!!!
lots of tools 3&4 jaw chucks
from what i measured us an 8” chuck capacity
approx 1.4mts high at the chuck end on its 1.4mt suds tray and stand
approx 60cm deep
i have just done a small batch run of parts using the 3&4 jaw chucks and it worked perfectly , the father in law is currently cleaning this up.
i have demolished the shed it’s in and would be good to sell this before i have to move it into storage.
lots of bits and pieces with it and he has some old engineering tools etc from when he was building a live steam engine, ill health means he has had to give that dream up some time ago
collection only near junction 4 M25
£900 or near offer
