Saw this at castle combe today at a track day. No details as no one was around.
Date tested 27 September 2013 PASS Mileage 19,911 miles MOT test number 3464 1067 3255 Test location View test location Expiry date 5 October 2014 Advisory notice item(s) Offside Front wheel bearing has slight play (2.5.A.3c) Centre Exhaust has a minor leak of exhaust gases (7.1.2) Under-trays fitted obscuring some underside components Engine covers fitted obscuring some components in the engine bay car has had iots of mods
Yesterday all over with Jenolite Anti Rust Remover, did a bit more this morning, then on with Jenolite Red Oxide Anti Rust Corrosion Zinc Primer. Just need a top coat and I can clean bits up and bolt back on
Ive got a ZZR1100 engine ( I had a complete running bike) it will be front mounted , custom made prop going to standard axle. I'm using all the bike electrics just to make life easy. As far as I got so far is to cut part of the passenger side floor and footwell out. Next is to drop the engine in and line it up and make some mounts
I was wondering if the engine could go above the rear axle (with a sprocket on) and connect the two via a chain. What brakes are you going to use for the front, I will stick with the rear drums but I want disks upfront
There has been a few Robins / Rialtos done with the engine in the back and chain driven. Not sure on the brakes yet. I remember seeing somewhere that Fiesta/Ka discs and callipers but need a mounting bracket made up