Got the throttle cleaned up a bit. That black goo was pretty nasty but some elbow grease and patience yielded this.
I'm not sure how to take the arm off the throttle shaft. I would like to give it a go because the arm is a bit crusty, especially after cleaning it up. Sometimes the screws holding the butterfly in are very tough to remove and I'm a little hesitant to try. I think sometimes they peen them or put thread locker on them.
Has anyone here had experience cad or yellow zinc plating? Found this kit and it looks pretty well done.
www.caswellplating.com/copy-cad-reg-and-zinc-plating-kit-1-5-gal.html
I'm not sure how to take the arm off the throttle shaft. I would like to give it a go because the arm is a bit crusty, especially after cleaning it up. Sometimes the screws holding the butterfly in are very tough to remove and I'm a little hesitant to try. I think sometimes they peen them or put thread locker on them.
Has anyone here had experience cad or yellow zinc plating? Found this kit and it looks pretty well done.
www.caswellplating.com/copy-cad-reg-and-zinc-plating-kit-1-5-gal.html