|
|
|
Sept 4, 2017 17:15:42 GMT
|
|
Does anyone know if a ford type 9 ,5speed gearbox fit a 2ltr ford twin cam 4i thanks carl
|
| |
|
|
|
|
|
Sept 4, 2017 20:08:20 GMT
|
|
yes
|
| |
|
|
mk2cossie
Club Retro Rides Member
Posts: 2,948 
Club RR Member Number: 77
|
Ford Type 9 mk2cossie
@mk2cossie
Club Retro Rides Member 77
|
Sept 4, 2017 20:25:50 GMT
|
Depends which bellhousing it has attached to it  |
| |
|
|
njw
Part of things
Posts: 226
|
|
Sept 4, 2017 20:48:26 GMT
|
|
As above, if the type 9 in question has a Ford 4 cylinder bell housing attached then it will fit an I4 twinky, however, check that it actually is a 4 cylinder 'box as the V6 'box has a longer input shaft so may not fit into the spigot bearing on the I4 engine.
Also, can I ask why? As the mt75 'box fitted to the 2.0 twin cam Sierras is a stronger 'box than the type 9.
|
| |
Last Edit: Sept 4, 2017 20:50:37 GMT by njw
|
|
|
|
|
Sept 5, 2017 17:35:38 GMT
|
|
I am looking for a mt75 but I'm struggling to get one and I have been offered a type 9 😎
|
| |
|
|
|
|
|
Sept 5, 2017 18:03:36 GMT
|
|
I'm in Cheshire, and have an MT75 with clutch, prop and mounting that came out of a mates Sierra 2.0 twin-cam, 90-J. It went off the road because the head gasket went. I never drove the car so I can't say what the box was like, but the chap who did drive it told me it was fine.
I bought it when the car was scrapped, because I didn't realise it had an integral bellhousing and thought I might be able to use it on my Vauxhall.
|
| |
|
|
|
|
|
|
|
|
I have a I4 RS2000 16v engine mated to a type 9 in my mk1 Escort(same black as TC). It fits straight in. You may have to try different length release bearings to take up some slack but that's it if using the rwd flywheel. If you have a fwd rs flywheel and clutch it still works but you have only half the clutch travel as the throw is different.
|
| |
|
|
|
|
|
|
|
|
Hi, I'm going to put a scorpio engine, the dohc 2000 16v, same engine as the escort mk5 rs2000 whit a little less hp, will it fit straight on the type 9 box? thinking of an mt75 later on but for now i'm only doing the engine swap. will the flywheel/clutch fit straight?
|
| |
|
|
