voodoo57
Club Retro Rides Member
That's not 2 metres! come a little...Closer!
Posts: 2,753 
Club RR Member Number: 137
|
Pinto Manifold Any idea?voodoo57
@voodoo57
Club Retro Rides Member 137
|
|
|
|
I have only had 1 other which was about 25 years ago, and like this one, it didn't have a name stamped on it or any markings, obviously for the Weber Fitment, does anyone know who made these? quite different, no idea on the power gains/loss? wold be interesting to know a bit more about it.
|
| |
|
|
|
|
|
|
|
|
|
|
Looks to be a worse design than standard IMO !
|
| |
|
|
|
|
|
|
|
|
depends what the inside looks like, casting looks fairly crude, reasonable length runners which would help get more out of it.
|
| |
|
|
|
|
|
|
|
|
Offset by the tight angles though maybe .
|
| |
|
|
|
|
|
Aug 19, 2017 10:12:06 GMT
|
|
Hi, That's a Ford Kent crossflow manifold.
Colin
|
| |
|
|
|
|
|
Aug 19, 2017 11:08:15 GMT
|
|
Looks like a crossflow no top bolt slot in middle i.e. it should have six bolts to fit it
|
| |
|
|
bortaf
Posted a lot
Posts: 4,549
|
|
Aug 19, 2017 23:16:03 GMT
|
As above, it's a Xflow GT manifold, the bolt holes for the cable bracket are on the wrong side for a pinto and missing a hole above the waterway give it away  |
| |
R.I.P photobucket
|
|
voodoo57
Club Retro Rides Member
That's not 2 metres! come a little...Closer!
Posts: 2,753
Club RR Member Number: 137
|
Pinto Manifold Any idea?voodoo57
@voodoo57
Club Retro Rides Member 137
|
Aug 20, 2017 20:10:50 GMT
|
|
Cheers for the replies folks!, there is a waterway in the centre, but only a small slit compared to the standard Ford inlet manifolds, yes, very crude to say the least design wise, it's now cable tied to my shed wall now, and staying there!
|
| |
|
|
